Shincor LIM KEG2001-50 Shincor Sil Silicone

Physical	Nominal Value	Unit	Test Method
Specific Gravity			ASTM D792
Molding Shrinkage - Flow		in/in	ASTM D955
Elastomers	Nominal Value	Unit	Test Method
Tensile Stress (100% Strain)		psi	ASTM D412
Tensile Strength (Yield)		psi	ASTM D412
Tensile Elongation (Break)		%	ASTM D412
Tear Strength		lbf/in	ASTM D624
Hardness	Nominal Value	Unit	Test Method
Durometer Hardness (Shore A)			ASTM D2240
Thermoset	Nominal Value	Unit	Test Method
Post Cure Time (302°F)		hr
Additional Information
Compression Set, ASTM D395, 22 hr, 302°F, Specimen post-cured 1 hr at 302°F: 32% Compression Set, ASTM D395, 22 hr, 302°F, Specimen post-cured 4 hrs at 392°F: 8% Viscosity, Part A: 1400 Pa.s Viscosity, Part B: 1300 Pa.s Cure Rate, ODR, 302°F, T10: 25 sec Cure Rate, ODR, 302°F, T90: 35 sec Press Cure, 5 min at 302°F
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Shincor LIM KEG2001-50, Shincor LIM KEG200150, Shincor LIM , ShincorLIMKEG200150, ShincorLIM, KEG 2001, LIMKEG 2001 50, LIMKEG 2001, LIMKEG2001-50, LIMKEG200150, LIMKEG2001:50, LIMKEG2001/50, LIMKEG2001+50, LIMKEG2001_50, LIMKEG2001 50, LIMKEG2001, KEG 2001 50, KEG2001-50, KEG200150, KEG2001:50, KEG2001/50, KEG2001+50, KEG2001_50, KEG2001 50, KEG2001, 200150, Silicone, Shincor Sil, 2001KEG, 2001LIMKEG
Features
Features may also be described by the following terms: Fast Cure, Fast Curing.

Notes

¹Typical properties: these are not to be construed as specifications.

Shincor LIM KEG2001-50