IDES Prospector Already have an account? Login Here

IDES

Shincor LIM KE2090-60

Silicone

Supplied by Shincor Silicones, Inc.

The technical datasheet with complete property values for Shincor LIM KE2090-60 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Uses 
  • Adhesives
Agency Ratings 
Appearance 
  • White
Forms 
  • Liquid
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Molding Shrinkage - Flow
in/in
 ASTM D955
Elastomers
Nominal Value
Unit
Test Method
Tensile Strength (Yield)
psi
 ASTM D412
Tensile Elongation (Break)
%
 ASTM D412
Tear Strength
lbf/in
 ASTM D624
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore A)
 
 ASTM D2240
Additional Information
Compression Set, ASTM D395, 22 hr, 302°F, Specimen post-cured 1 hr at 302°F: 53%
Compression Set, ASTM D395, 22 hr, 302°F, Specimen post-cured 4 hrs at 392°F: 9%
Viscosity, Part A: 450 Pa.s
Viscosity, Part B: 700 Pa.s
Cure Rate, ODR, 248°F, T10: 94 sec
Cure Rate, ODR, 248°F, T90: 154 sec
Press Cure, 10 min at 248°F
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Shincor LIM KE2090-60, Shincor LIM KE209060, Shincor LIM , ShincorLIMKE209060, ShincorLIM, KE 2090, LIMKE 2090 60, LIMKE 2090, LIMKE2090-60, LIMKE209060, LIMKE2090:60, LIMKE2090/60, LIMKE2090+60, LIMKE2090_60, LIMKE2090 60, LIMKE2090, KE 2090 60, KE2090-60, KE209060, KE2090:60, KE2090/60, KE2090+60, KE2090_60, KE2090 60, KE2090, 209060, Silicone, Shincor Sil, 2090KE, 2090LIMKE
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): USP (1).
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.