Already have an account? Login Here

IDES

Shincor LIM X-34-1665

Silicone

Supplied by Shincor Silicones, Inc.

The technical datasheet with complete property values for Shincor LIM X-34-1665 is available to members of the Prospector Plastics Database.
Register to view full datasheet.

General
Material Status	Commercial: Active
Availability	North America
Features	Low Hardness
Appearance	Translucent
Forms	Liquid

Physical	Nominal Value	Unit	Test Method
Specific Gravity			ASTM D792
Molding Shrinkage - Flow		in/in	ASTM D955
Elastomers	Nominal Value	Unit	Test Method
Tensile Strength (Yield)		psi	ASTM D412
Tensile Elongation (Break)		%	ASTM D412
Tear Strength		lbf/in	ASTM D624
Hardness	Nominal Value	Unit	Test Method
Durometer Hardness (Shore A)			ASTM D2240
Thermoset	Nominal Value	Unit	Test Method
Post Cure Time (302°F)		hr
Additional Information
Viscosity, Part A: 350 Pa.s Viscosity, Part B: 355 Pa.s Cure Rate, ODR, 302°F, T10: 22 sec Cure Rate, ODR, 302°F, T90: 53 sec Press Cure, 10 min at 248°F
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Shincor LIM X-34-1665, Shincor LIM X341665, Shincor LIM , ShincorLIMX341665, ShincorLIM, LIMX-34-1665, LIMX341665, LIMX:34:1665, LIMX/34/1665, LIMX+34+1665, LIMX_34_1665, LIMX 34 1665, LIMX34, LIMX, X-34-1665, X341665, X:34:1665, X/34/1665, X+34+1665, X_34_1665, X 34 1665, X34, 341665, Silicone, Shincor Sil, 34X, 34LIMX
Features
Features may also be described by the following terms: Low Hardness.

Notes

¹Typical properties: these are not to be construed as specifications.

Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.