IDES Prospector Already have an account? Login Here

IDES

Adell PC YS-10

Polycarbonate Alloy

Supplied by Adell Plastics, Inc.

The technical datasheet with complete property values for Adell PC YS-10 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Forms 
  • Pellets
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
ASTM D792
Melt Mass-Flow Rate (MFR) (300°C/1.2 kg)
g/10 min
ASTM D1238
Molding Shrinkage - Flow
in/in
ASTM D955
Water Absorption (24 hr)
%
ASTM D570
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength
psi
ASTM D638
Tensile Elongation (Break)
%
ASTM D638
Flexural Modulus
psi
ASTM D790
Flexural Strength
psi
ASTM D790
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (73°F, 0.125 in)
ft·lb/in
ASTM D256
Hardness
Nominal Value
Unit
Test Method
Rockwell Hardness (M-Scale)
 
ASTM D785
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load
    ASTM D648
66 psi, Unannealed
°F
 
264 psi, Unannealed
°F
 
Additional Information
Other melt flow grades available.
Melt Flow Rate, ASTM D1238, 300°C/1.2 kg: 4 to 6 g/10 min
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Adell PC YS-10, Adell PC YS10, Adell PC , AdellPCYS10, AdellPC, YS, PCYS-10, PCYS10, PCYS:10, PCYS/10, PCYS+10, PCYS_10, PCYS 10, PCYS, YS-10, YS10, YS:10, YS/10, YS+10, YS_10, YS 10, Polycarbonate Alloy, PC Alloy, Polycarbonate, PC, Adell, PolycarbonateAlloy, PCAlloy, 10YS, 10PCYS
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.