IDES Prospector Already have an account? Login Here

IDES

Elastollan® 590 A 53

Thermoplastic Polyurethane Elastomer (Polyester)

Supplied by BASF Polyurethanes GmbH

The technical datasheet with complete property values for Elastollan® 590 A 53 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
Forms 
  • Pellets
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ISO 1183
Mechanical
Nominal Value
Unit
Test Method
Tensile Stress (Break)
psi
 ISO 527-2
Tensile Strain (Break)
%
 ISO 527-2
Elastomers
Nominal Value
Unit
Test Method
Tear Strength
lbf/in
 ISO 34-1
Hardness
Nominal Value
Unit
Test Method
Shore Hardness
     ISO 868
Shore A
 
  
Shore D
 
  
Additional Information
Note: These properties were tested in accordance with the DIN test standard.
Abrasion Loss, DIN 53516: 35 mm³
Related Terminology
This supplier and product may also be known by these terms: Elastolan, Ellastolan

Product names can be difficult to match. You may have searched any one of these terms to find this product: Elastollan® 590 A 53, Elastollan 590 A 53, Elastollan® , Elastollan, Elastollan590A53, 590 A 53, 590A, A53, 590A53, Thermoplastic Polyurethane Elastomer, Thermoplastic Polyurethane Elastomer (Polyester), Thermoplastic Polyurethane Elastomer Polyester, TPU-Polyester, TPUPolyester, TPU:Polyester, TPU/Polyester, TPU+Polyester, TPU_Polyester, TPU Polyester, Thermoplastic Polyurethane, TPU, Elastogran Euro, ThermoplasticPolyurethaneElastomerPolyester, ThermoplasticPolyurethane, A590
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.