IDES Prospector Already have an account? Login Here

IDES

Orevac® 18350

Linear Low Density Polyethylene

Supplied by Arkema

The technical datasheet with complete property values for Orevac® 18350 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
OREVAC 18350 is a maleic anhydride grafted polyethylene used in the manufacturing of three layer MDPE or HDPE coating for steel pipeline.
OREVAC 18350 is mainly used in pipe coating to have good adhesion performances between an epoxy primer and LACQTENE 2006PBK35 from Total Petrochemicals.
OREVAC 18350 combined with MDPE or HDPE and a proper epoxy fulfil the requirement of different application standards such as NFA 49-710 or DIN 30670 when applied in the rules of art.
OREVAC 18350 is recommended for pipeline service temperature up to 80°C.
General  
Material Status 
  • Commercial: Active
Availability 
  • Africa & Middle East
  • Asia Pacific
  • Europe
  • Latin America
  • North America
  • South America
Features 
  • Good Adhesion
Uses 
  • Pipe Coatings
Forms 
  • Pellets
Processing Method 
  • Extrusion Coating
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ISO 1183
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ISO 1133
Mechanical
Nominal Value
Unit
Test Method
Tensile Stress (Yield, Compression Molded)
psi
 ISO 527-2/10
Tensile Strain (Break, Compression Molded)
%
 ISO 527-2/10
Hardness
Nominal Value
Unit
Test Method
Shore Hardness (Shore D)
 
 ISO 868
Thermal
Nominal Value
Unit
Test Method
Vicat Softening Temperature
°F
 ISO 306
Melting Temperature
°F
 DSC
Additional Information
Elongation @ Break, ISO R527-2: >600%
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Orevac® 18350, Orevac 18350, Orevac® , Orevac, Orevac18350, 18350, Polyethylene, Linear Low Density, Polyethylene Linear Low Density, LLDPE, Polyethylene, PE, Arkema, PolyethyleneLinearLowDensity
Features
Features may also be described by the following terms: Good Adhesion.
Uses
Uses may also be described by the following terms: Pipe Coatings, Pipe Coating.
Extrusion
Nominal Value
Unit
 
Cylinder Zone 1 Temp.
°F
  
Cylinder Zone 2 Temp.
°F
  
Cylinder Zone 3 Temp.
°F
  
Cylinder Zone 4 Temp.
°F
  
Cylinder Zone 5 Temp.
°F
  
Die Temperature
°F
  
Extrusion Notes
Fittings - Channels Temp: 220-230°C
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.