Already have an account? Login Here

IDES

Lionpol LC-60060

Thermoplastic Elastomer

Supplied by Lion Polymers Incorporated

The technical datasheet with complete property values for Lionpol LC-60060 is available to members of the Prospector Plastics Database.
Register to view full datasheet.

General
Material Status	Commercial: Active
Availability	North America
Features	Low Compression Set
Forms	Pellets

Physical	Nominal Value	Unit	Test Method
Melt Mass-Flow Rate (MFR) (230°C/2.16 kg)		g/10 min	ASTM D1238
Molding Shrinkage			ASTM D955
Flow		in/in
Across Flow		in/in
Elastomers	Nominal Value	Unit	Test Method
Tensile Stress (100% Strain)		psi	ASTM D412
Tensile Strength (Break)		psi	ASTM D412
Tensile Elongation (Break)		%	ASTM D412
Compression Set			ASTM D395
73°F, 22.0 hr		%
158°F, 22.0 hr		%
212°F, 22.0 hr		%
Hardness	Nominal Value	Unit	Test Method
Durometer Hardness (Shore A)			ASTM D2240
Additional Information
Permanent Set: 7%
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Lionpol LC-60060, Lionpol LC60060, Lionpol , LionpolLC60060, LC, LC-60060, LC60060, LC:60060, LC/60060, LC+60060, LC_60060, LC 60060, Thermoplastic Elastomer, TPE, Lion Polymers, ThermoplasticElastomer, 60060LC
Features
Features may also be described by the following terms: Low Compression Set.

Injection	Nominal Value	Unit
Rear Temperature		°F
Front Temperature		°F
Nozzle Temperature		°F
Mold Temperature		°F
Back Pressure		psi

Notes

¹Typical properties: these are not to be construed as specifications.

Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.