IDES Prospector Already have an account? Login Here

IDES

INEOS PP H01H-00

Polypropylene Homopolymer

Supplied by INEOS Olefins & Polymers USA

The technical datasheet with complete property values for INEOS PP H01H-00 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
Grade H01H-00 is a low flow rate homopolymer designed for extrusion or injection molding. This material meets the requirements of the U. S. Food and Drug Administration as specified in 21 CFR 177.1520.
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Features 
  • Food Contact Acceptable
  • Good Heat Aging Resistance
  • Homopolymer
  • Low Flow
 
Uses 
  • Profiles
  • Sheet
 
Agency Ratings 
RoHS Compliance 
Forms 
  • Pellets
Processing Method 
  • Extrusion
  • Injection Molding
  • Profile Extrusion
  • Sheet Extrusion
 
Physical
Nominal Value
Unit
Test Method
Melt Mass-Flow Rate (MFR) (230°C/2.16 kg)
g/10 min
ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength (Yield, 73°F)
psi
ASTM D638
Tensile Elongation (Break, 73°F)
%
ASTM D638
Flexural Modulus (73°F)
psi
ASTM D790A
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (73°F, 0.125 in)
ft·lb/in
ASTM D256
Hardness
Nominal Value
Unit
Test Method
Rockwell Hardness (R-Scale)
 
ASTM D785
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load (66 psi, Unannealed)
°F
ASTM D648
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: INEOS PP H01H-00, INEOS PP H01H00, INEOS PP , INEOSPPH01H00, INEOSPP, H 01 H, PPH 01 H 00, PPH 01 H, H01H, PPH01H-00, PPH01H00, PPH01H:00, PPH01H/00, PPH01H+00, PPH01H_00, PPH01H 00, PPH01, PPH01H, H 01 H 00, H01H-00, H01H00, H01H:00, H01H/00, H01H+00, H01H_00, H01H 00, H01, 01H, H00, Polypropylene Homopolymer, PP Homopolymer, Polypropylene, PP, Ineos USA, PolypropyleneHomopolymer, PPHomopolymer, 01PPH
Features
Features may also be described by the following terms: Low Flow, Low Melt, Low MFI, Good Heat Aging Resistance.
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1).
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.