IDES Prospector Already have an account? Login Here

IDES

Pemex PX 22004

Low Density Polyethylene

Supplied by Pemex Petroquímica

The technical datasheet with complete property values for Pemex PX 22004 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Latin America
  • North America
  
Features 
  • Homopolymer
Agency Ratings 
Forms 
  • Pellets
Processing Method 
  • Blow Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ASTM D1505
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ASTM D1238
Environmental Stress-Cracking Resistance
hr
 ASTM D1693
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength (Break)
psi
 ASTM D638
Tensile Elongation (Break)
%
 ASTM D638
Flexural Modulus
psi
 ASTM D790
Films
Nominal Value
Unit
Test Method
Dart Drop Impact
g
 ASTM D1709
Elastomers
Nominal Value
Unit
Test Method
Tear Strength
lbf/in
 ASTM D624
Additional Information
Color, NOM-E-139 or ALATHENE 48: A
Cut, NOM-E-139 or ALATHENE 48: A
Contamination, NOM-E-139 or ALATHENE 48: A
Film, NOM-E-139 or ALATHENE 48: T
The value listed as Tear Strength ASTM D624, was tested in accordance with ASTM D1004.
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Pemex PX 22004, Pemex , PemexPX22004, PX 22004, PX22004, Polyethylene, Low Density, Polyethylene Low Density, LDPE, Polyethylene, PE, PolyethyleneLowDensity, 22004PX
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1).
Injection
Nominal Value
Unit
 
Processing (Melt) Temp
°F
  
Injection Notes
Dice: 190-220°C
Relation of Blown: 1.5 to 3 times the diameter of the dice.
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.