IDES Prospector Already have an account? Login Here

IDES

Aaroprene® ATPR 1000 50A

Thermoplastic Elastomer

Supplied by Aaron Industries Corp.

The technical datasheet with complete property values for Aaroprene® ATPR 1000 50A is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Appearance 
  • Colors Available
Forms 
  • Pellets
Processing Method 
  • Extrusion
  • Film Extrusion
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Modulus
psi
 ASTM D412
Taber Abrasion Resistance (1000 Cycles, H-18 Wheel)
mg
 ASTM D1044
Elastomers
Nominal Value
Unit
Test Method
Tensile Strength (Yield)
psi
 ASTM D412
Tensile Elongation (Break)
%
 ASTM D412
Tear Strength 2
lbf/in
 ASTM D624
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore A)
 
 ASTM D2240
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Aaroprene® ATPR 1000 50A, Aaroprene ATPR 1000 50A, Aaroprene® , Aaroprene, AaropreneATPR100050A, ATPR 1000 50 A, ATPR 1000 50A, ATPR1000, 100050, 50A, ATPR100050A, Thermoplastic Elastomer, TPE, Aaron Industries, ThermoplasticElastomer, 1000ATPR
Injection
Nominal Value
Unit
 
Rear Temperature
°F
  
Middle Temperature
°F
  
Front Temperature
°F
  
Nozzle Temperature
°F
  
Injection Pressure
psi
  
Injection Rate
 
  
Back Pressure
psi
  
Screw Speed
rpm
  
Injection Notes
Injection Time: 3 sec
Hold Time: 5 sec
Clamp Time: 10 sec
Cycle Time: 20 sec
Extrusion
Nominal Value
Unit
 
Cylinder Zone 1 Temp.
°F
  
Cylinder Zone 2 Temp.
°F
  
Cylinder Zone 3 Temp.
°F
  
Cylinder Zone 4 Temp.
°F
  
Cylinder Zone 5 Temp.
°F
  
Melt Temperature
°F
  
Die Temperature
°F
  
Extrusion Notes
L/D Ratio: 24:1
Low Compression Ratios
Deep Flighted Metering Sections
Film Extrusion Melt Temperature: 325 to 375°F
Notes
1Typical properties: these are not to be construed as specifications.
2Die C
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.