IDES Prospector Already have an account? Login Here

IDES

FRAGOM PR/800

Polyolefin

Supplied by Crosspolimeri S.p.A.

The technical datasheet with complete property values for FRAGOM PR/800 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
FRAGOM is the trade-mark of our flame retardant halogen free polyolefin thermoplastic compounds.
FRAGOM PR/800 is a flexible flame retardant polyolefin thermoplastic compound having high temperature index and good oxygen index, suitable for cable sheathing and insulation.
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
Features 
  • Flame Retardant
  • Halogen Free
  
Uses 
  • Cable Jacketing
Agency Ratings 
 
Forms 
  • Pellets
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Melt Mass-Flow Rate (MFR) (190°C/21.6 kg)
g/10 min
 ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Stress (Yield)
psi
 IEC 60811
Tensile Strain (Break)
%
 IEC 60811
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore D)
 
 ASTM D2240
Aging
Nominal Value
Unit
Test Method
Change in Tensile Strength in Air (230°F, 168 hr)
%
 IEC 60811
Change in Tensile Strain at Break in Air (230°F, 168 hr)
%
 IEC 60811
Change in Tensile Stress (158°F, 4 hr, in SAE 20 Oil)
%
 IEC 60811
Change in Tensile Strain at Break (158°F, 4 hr, in SAE 20 Oil)
%
 IEC 60811
Flammability
Nominal Value
Unit
Test Method
Oxygen Index
%
 ASTM D2863
Corrosive Gas in Smoke - oH
 
 IEC 60754-2
Halogen Content
%
 IEC 60754-1
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: FRAGOM PR/800, FRAGOM PR800, FRAGOM , FRAGOMPR800, PR, PR/800, PR800, PR:800, PR+800, PR-800, PR_800, PR 800, Polyolefin, Unspecified, Polyolefin Unspecified, Polyolefin, Crosspolimeri, PolyolefinUnspecified, 800PR
Features
Features may also be described by the following terms: Zero Halogen Content, Halogen Free.
Agency Ratings
This plastic material has 2 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): BS (1), CEI (1).
Extrusion
Nominal Value
Unit
 
Cylinder Zone 1 Temp.
°F
  
Cylinder Zone 2 Temp.
°F
  
Cylinder Zone 3 Temp.
°F
  
Cylinder Zone 4 Temp.
°F
  
Cylinder Zone 5 Temp.
°F
  
Die Temperature
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.