GETILAN ATP/144 Crosspolimeri Polyethylene, Crosslinked

Product Description

GETILAN is the trade-mark of our crosslinkable polythene.
GETILAN ATP/144 GRAFTING is a high density chemically crosslinkable polythene to produce relatively flexible hoses suitable for hydro-thermosanitary features and also for potable water conduction.
It is a conveniently grafted polythene able to react in presence of moisture and of catalyst. We normally suggest our type MAC/100 PSF.

REACTION BETWEEN GRAFTING AND CATALYST:
These two polythenes, separately stored, must be mixed before starting extrusion in the ratio:
GRAFTING/CATALYST 95/5

General

Material Status

Commercial: Active

Availability

Europe

Features

Crosslinkable

Good Flexibility

High Density

Uses

Piping

Agency Ratings

Forms

Pellets

Processing Method

Extrusion

Pipe Extrusion

Physical	Nominal Value	Unit	Test Method
Density		g/cm³	ISO 1183
Melt Mass-Flow Rate (MFR) (190°C/5.0 kg)		g/10 min	ASTM D1238
Mechanical	Nominal Value	Unit	Test Method
Tensile Stress (Yield)		psi	IEC 60811
Tensile Strain (Break)		%	IEC 60811
Hardness	Nominal Value	Unit	Test Method
Durometer Hardness (Shore D)			ASTM D2240
Thermal	Nominal Value	Unit	Test Method
Vicat Softening Temperature		°F	ISO 306
Service Temperature		°F
Additional Information	Nominal Value	Unit	Test Method
Pressure Test
203°F²
203°F³
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: GETILAN ATP/144, GETILAN ATP144, GETILAN , GETILANATP144, ATP, ATP/144, ATP144, ATP:144, ATP+144, ATP-144, ATP_144, ATP 144, Polyethylene, Crosslinked, Polyethylene Crosslinked, XLPE, Polyethylene, PE, Crosspolimeri, PolyethyleneCrosslinked, 144ATP
Features
Features may also be described by the following terms: High Density, High Specific Gravity, Good Flexibility, Flexible.
Uses
Uses may also be described by the following terms: Piping, Pipe.
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): DIN (1).

Extrusion	Nominal Value	Unit
Cylinder Zone 1 Temp.		°F
Cylinder Zone 2 Temp.		°F
Cylinder Zone 3 Temp.		°F
Cylinder Zone 4 Temp.		°F
Cylinder Zone 5 Temp.		°F
Die Temperature		°F
Extrusion Notes
CROSSLINKING: Crosslinking of the finished product is obtained by: Immersion of the bobbin into hot water at 85/90°C for two hours (up to 3 mm thickness). Steam treatment at 0.15 bar for 5/6 hours.

GETILAN ATP/144

Crosslinked Polyethylene

Supplied by Crosspolimeri S.p.A.