IDES Prospector Already have an account? Login Here

IDES

Sanren DJ210

Low Density Polyethylene

Supplied by SINOPEC Shanghai Petrochemical Co. Ltd.

The technical datasheet with complete property values for Sanren DJ210 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
Features 
  • Acid Resistant
  • Alkali Resistant
  • Crosslinkable
  • Good Chemical Resistance
  • High Monomer Content
  • Homopolymer
  • Low Density
  • Salt Water/Spray Resistant
Uses 
  • Wire & Cable Applications
Forms 
  • Pellets
Processing Method 
  • Extrusion
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ASTM D1505
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength
psi
 ASTM D638
Electrical
Nominal Value
Unit
Test Method
Dielectric Constant
 
 ASTM D150
Dissipation Factor
 
 ASTM D150
Additional Information
Cleanliness, GB 12670: <=20 piece/kg
Water Content, Q/SH012.07.05: On-spec.
Hue, Q/SH012.07.05: <=-16
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Sanren DJ210, Sanren , SanrenDJ210, DJ 210, DJ210, Polyethylene, Low Density, Polyethylene Low Density, LDPE, Polyethylene, PE, Sinopec Shanghai, PolyethyleneLowDensity, 210DJ
Features
Features may also be described by the following terms: Low Density, Low Specific Gravity, Salt Water Spray Resistant, Salt Water Resistant, Salt Spray Resistant, High Monomer Content, Good Chemical Resistance, Chemical Resistant.
Uses
Uses may also be described by the following terms: Wire and Cable Applications, Wire & Cable Applications.
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.