IDES Prospector Already have an account? Login Here

IDES

HANWHA LDPE 5315

Low Density Polyethylene

Supplied by Hanwha Chemical

The technical datasheet with complete property values for HANWHA LDPE 5315 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
HANWHA LDPE 5315 is manufactured by ICI autoclave high pressure process and designed for variety of film application such as general purpose film and agricultural film. LDPE 5315 has well balanced property of mechanical and optical property.
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
  • Europe
  
Features 
  • General Purpose
  • Opticals
  
Uses 
  • Agricultural Applications
  • Film
  
Forms 
  • Pellets
Processing Method 
  • Film Extrusion
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ASTM D1505
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength (Break)
psi
 ASTM D638
Tensile Elongation (Break)
%
 ASTM D638
Films
Nominal Value
Unit
Test Method
Film Thickness - Tested
mil
  
Tensile Strength
     ASTM D882
MD: Break, 2.4 mil
psi
  
TD: Break, 2.4 mil
psi
  
Tensile Elongation
     ASTM D882
MD: Break, 2.4 mil
%
  
TD: Break, 2.4 mil
%
  
Thermal
Nominal Value
Unit
Test Method
Brittleness Temperature
°F
 ASTM D746
Vicat Softening Temperature
°F
 ASTM D1525
Melting Temperature
°F
  
Optical
Nominal Value
Unit
Test Method
Haze (2.36 mil)
%
 ASTM D1003
Additional Information
Tensile Tear Strength, ASTM D1004, 0.06 mm, MD: 400 kg/cm
Tensile Tear Strength, ASTM D1004, 0.06 mm, TD: 550 kg/cm
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: HANWHA LDPE 5315, HANWHA LDPE , HANWHALDPE5315, HANWHALDPE, LDPE 5315, LDPE5315, LDPE, 5315, Polyethylene, Low Density, Polyethylene Low Density, Polyethylene, PE, Hanwha, PolyethyleneLowDensity, 5315LDPE
Extrusion
Nominal Value
Unit
 
Melt Temperature
°F
  
Extrusion Notes
Blow-up Ratio: 2 to 3
Optimum Gage Range: 0.05 to 0.15 mm
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.