IDES Prospector Already have an account? Login Here

IDES

Unilex™ UP.70.960

High Density Polyethylene

Supplied by United Polychem

The technical datasheet with complete property values for Unilex™ UP.70.960 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Features 
  • Food Contact Acceptable
  • Good Impact Resistance
  • Good Stiffness
  • High Density
 
Uses 
  • Containers
  • Food Packaging
  • Sheet
Agency Ratings 
 
Forms 
  • Pellets
Processing Method 
  • Blow Molding
Physical
Nominal Value
Unit
Test Method
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
ASTM D1238
Environmental Stress-Cracking Resistance (100% Igepal, F50)
hr
ASTM D1693A
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength 2 (Yield)
psi
ASTM D638
Tensile Elongation 2 (Break)
%
ASTM D638
Flexural Modulus
psi
ASTM D790
Thermal
Nominal Value
Unit
Test Method
Brittleness Temperature
°F
ASTM D746
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Unilex™ UP.70.960, Unilex UP70960, Unilex™ , Unilex, UnilexUP70960, UP 70 960, UP.70.960, UP70960, UP70, 70960, Polyethylene, High Density, Polyethylene High Density, HDPE, Polyethylene, PE, United Polychem, PolyethyleneHighDensity, 70UP
Features
Features may also be described by the following terms: Good Impact Resistance, Good Stiffness, High Density, High Specific Gravity.
Uses
Uses may also be described by the following terms: Food Packaging.
Agency Ratings
This plastic material has 2 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1), ASTM (1).
Injection Notes
Blow Molding Recommended Stock Temperature: 340 - 400°F
Notes
1Typical properties: these are not to be construed as specifications.
2Type IV, 2.0 in/min
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.