IDES Prospector Already have an account? Login Here

IDES

BESTPOLUX PCX

Polycarbonate

Supplied by Triesa Plastics

The technical datasheet with complete property values for BESTPOLUX PCX is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
PC natural lubrified with V-0 quality is characterized for good flame retardant quality and injection behaviour.
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
Additive 
  • Lubricant
Features 
  • Flame Retardant
  • Good Processability
  • Lubricated
Appearance 
  • Natural Color
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ISO 1183
Melt Mass-Flow Rate (MFR)
g/10 min
 ISO 1133
Molding Shrinkage
%
 ISO 294-4
Water Absorption (73°F, 24 hr)
%
 ISO 62
Mechanical
Nominal Value
Unit
Test Method
Tensile Modulus
psi
 ISO 527-2
Tensile Stress (Yield)
psi
 ISO 527-2
Tensile Strain (Break)
%
 ISO 527-2
Impact
Nominal Value
Unit
Test Method
Charpy Notched Impact Strength (73°F)
ft·lb/in²
 ISO 179
Charpy Unnotched Impact Strength
     ISO 179
-40°F
 
  
73°F
 
  
Hardness
Nominal Value
Unit
Test Method
Shore Hardness (Shore D)
 
 ISO 868
Thermal
Nominal Value
Unit
Test Method
Heat Deflection Temperature
      
66 psi, Unannealed
°F
 ISO 75-2/B
264 psi, Unannealed
°F
 ISO 75-2/A
Vicat Softening Temperature
°F
 ISO 306
Electrical
Nominal Value
Unit
Test Method
Surface Resistivity
ohms
 IEC 60093
Flammability
Nominal Value
Unit
Test Method
Flame Rating - UL
 
 UL 94
Glow Wire Ignition Temperature
°F
 IEC 60695-2-13
Additional Information
Humidity Pellets, ISO 1110: 0.2%
Flammability Speed, FMV 302:<100 mm/min
Tracking Index (C.T.I), IEC 112: 225 kV/mm
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: BESTPOLUX PCX, BESTPOLUX , BESTPOLUXPCX, PCX, Polycarbonate, PC, Triesa
Features
Features may also be described by the following terms: Good Processability, Easy Processing.
Injection
Nominal Value
Unit
 
Drying Temperature
°F
  
Drying Time
hr
  
Processing (Melt) Temp
°F
  
Mold Temperature
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.