Juner PA-A3-FD-Aa-1 Zhejiang Juner Polyamide 6 (Unspecified Filler\Reinfor.)

Physical	Nominal Value	Unit	Test Method
Density		g/cm³	ISO 1183
Water Absorption (73°F, 24 hr)		%	ISO 62
Mechanical	Nominal Value	Unit	Test Method
Tensile Stress (Yield)		psi	ISO 527-2
Flexural Strength		psi	ISO 178
Impact	Nominal Value	Unit	Test Method
Charpy Notched Impact Strength		ft·lb/in²	ISO 179
Charpy Unnotched Impact Strength		ft·lb/in²	ISO 179
Thermal	Nominal Value	Unit	Test Method
Heat Deflection Temperature (264 psi, Unannealed)		°F	ISO 75-2/A
Electrical	Nominal Value	Unit	Test Method
Volume Resistivity		ohm·cm	ASTM D257
Comparative Tracking Index		V	IEC 60112
Flammability	Nominal Value	Unit	Test Method
Flame Rating - UL (0.126 in)			UL 94
Additional Information
Ash Content, BG/9345: 19% Granule Size: 3 mm diameter x 3 to 5 mm
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Juner PA-A3-FD-Aa-1, Juner PAA3FDAa1, Juner , JunerPAA3FDAa1, PA, PA A 3 FD Aa 1, PA-A3-FD-Aa-1, PAA3FDAa1, PA:A3:FD:Aa:1, PA/A3/FD/Aa/1, PA+A3+FD+Aa+1, PA_A3_FD_Aa_1, PA A3 FD Aa 1, PAA, A3, 3FD, FDAa, Aa1, Polyamide 6, Nylon 6, Polyamide, Nylon, pa6, Zhejiang Juner, Polyamide6, Nylon6, APA
Generic Name
Generic Name may also be described by the following terms: PA6.

Injection	Nominal Value	Unit
Drying Temperature		°F
Drying Time		hr
Rear Temperature		°F
Middle Temperature		°F
Front Temperature		°F
Processing (Melt) Temp		°F
Mold Temperature		°F
Injection Pressure		psi
Injection Notes
The drying conditions above are for a horizontal oven dryer. Injection Speed: 30 to 80% Vacuum Drying Temperature, -0.08 MPa: 110°C Vacuum Drying Time, -0.08 MPa: 2hr Chute Air Drying Temperature: 120°C Chute Air Drying Time, -0.08 MPa: 5hr

Notes

¹Typical properties: these are not to be construed as specifications.

Juner PA-A3-FD-Aa-1