Juner PP8 Zhejiang Juner Polypropylene, Unspecified

Physical	Nominal Value	Unit	Test Method
Density		g/cm³	ISO 1183
Molding Shrinkage		%	ISO 294-4
Mechanical	Nominal Value	Unit	Test Method
Tensile Stress (Yield)		psi	ISO 527-2
Flexural Strength		psi	ISO 178
Impact	Nominal Value	Unit	Test Method
Charpy Notched Impact Strength		ft·lb/in²	ISO 179
Charpy Unnotched Impact Strength		ft·lb/in²	ISO 179
Hardness	Nominal Value	Unit	Test Method
Ball Indentation Hardness		psi	ISO 2039-1
Thermal	Nominal Value	Unit	Test Method
Heat Deflection Temperature (66 psi, Unannealed)		°F	ISO 75-2/B
Electrical	Nominal Value	Unit	Test Method
Volume Resistivity		ohm·cm	ASTM D257
Additional Information
Aging Resistance, 150°C: 700-1300 hr Ash Content, BG/9345: 38% Chromatism, Delta E: 1 Granule Size: 4 mm diameter x 3 to 5 mm
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Juner PP8, Juner , JunerPP8, PP 8, PP8, Polypropylene, Unspecified, Polypropylene Unspecified, PP, Unspecified, PP Unspecified, Polypropylene, PP, Zhejiang Juner, PolypropyleneUnspecified, PPUnspecified, 8PP
Generic Name
Generic Name may also be described by the following terms: Polypropilene, Polypropelene.
Uses
Uses may also be described by the following terms: Automotive Applications, Automotive Sector.

Injection	Nominal Value	Unit
Drying Temperature		°F
Drying Time		hr
Rear Temperature		°F
Middle Temperature		°F
Front Temperature		°F
Processing (Melt) Temp		°F
Mold Temperature		°F
Injection Pressure		psi
Injection Notes
The drying conditions above are for a horizontal oven dryer. Vacuum Drying Temperature: 170 to 250°C Chute Air Drying Temperature: 90°C Chute Air Drying Time, -0.08 MPa: 2hr

Notes

¹Typical properties: these are not to be construed as specifications.

Juner PP8