Juner PP-610-M5 Zhejiang Juner Polypropylene, Unspecified

Physical	Nominal Value	Unit	Test Method
Density		g/cm³	ISO 1183
Molding Shrinkage		%	ISO 294-4
Mechanical	Nominal Value	Unit	Test Method
Tensile Stress (Yield)		psi	ISO 527-2
Flexural Strength		psi	ISO 178
Impact	Nominal Value	Unit	Test Method
Charpy Notched Impact Strength		ft·lb/in²	ISO 179
Charpy Unnotched Impact Strength			ISO 179
Thermal	Nominal Value	Unit	Test Method
Heat Deflection Temperature (66 psi, Unannealed)		°F	ISO 75-2/B
Electrical	Nominal Value	Unit	Test Method
Volume Resistivity		ohm·cm	ASTM D257
Additional Information
Chromatism, Delta E: 1 Granule Size: 4 mm diameter x 3 to 5 mm
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Juner PP-610-M5, Juner PP610M5, Juner , JunerPP610M5, PP, PP 610 M 5, PP-610-M5, PP610M5, PP:610:M5, PP/610/M5, PP+610+M5, PP_610_M5, PP 610 M5, PP610, 610M, M5, Polypropylene, Unspecified, Polypropylene Unspecified, PP, Unspecified, PP Unspecified, Polypropylene, Zhejiang Juner, PolypropyleneUnspecified, PPUnspecified, 610PP
Generic Name
Generic Name may also be described by the following terms: Polypropilene, Polypropelene.
Uses
Uses may also be described by the following terms: Power Tools, Tools.

Injection	Nominal Value	Unit
Drying Temperature		°F
Drying Time		hr
Rear Temperature		°F
Middle Temperature		°F
Front Temperature		°F
Processing (Melt) Temp		°F
Mold Temperature		°F
Injection Pressure		psi
Injection Notes
The drying conditions above are for a horizontal oven dryer. Vacuum Drying Temperature: 165 to 250°C Chute Air Drying Temperature: 90°C Chute Air Drying Time, -0.08 MPa: 2hr

Juner PP-610-M5