IDES Prospector Already have an account? Login Here

IDES

UNISOFT ADHESION™ AD-65A-NT-1-01

Styrene Ethylene Butylene Styrene Block Copolymer

Supplied by UNITED SOFT PLASTICS, Inc.

The technical datasheet with complete property values for UNISOFT ADHESION™ AD-65A-NT-1-01 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
TPE Compound based on Styrene-Ethylene/Butylene-Styrene Block Copolymer.
Special bonding grade to PC/ABS, PC/PBT, PC, ABS, PBT and PET.
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Features 
  • Block Copolymer
  • Bondability
  • Good Adhesion
Uses 
  • Adhesives
  • Bonding
  • Handles
  • Overmolding
  • Seals
Appearance 
  • Natural Color
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Molding Shrinkage - Flow
in/in
 ASTM D955
Elastomers
Nominal Value
Unit
Test Method
Tensile Strength (Yield)
psi
 ASTM D412
Tensile Elongation (Break)
%
 ASTM D412
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore A)
 
 ASTM D2240
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: UNISOFT ADHESION™ AD-65A-NT-1-01, UNISOFT ADHESION AD65ANT101, UNISOFT ADHESION™ , UNISOFT ADHESION, UNISOFTADHESIONAD65ANT101, UNISOFTADHESION, AD, AD 65 A NT 1 01, AD-65A-NT-1-01, AD65ANT101, AD:65A:NT:1:01, AD/65A/NT/1/01, AD+65A+NT+1+01, AD_65A_NT_1_01, AD 65A NT 1 01, AD65, 65A, ANT, NT1, 101, Styrene Ethylene Butylene Styrene Block Copolymer, SEBS, Thermoplastic Elastomer, TPE, United Soft Plastics, StyreneEthyleneButyleneStyreneBlockCopolymer, ThermoplasticElastomer, 65AD
Features
Features may also be described by the following terms: Good Adhesion, Bondability, Bondable, Block Copolymer.
Injection
Nominal Value
Unit
 
Drying Temperature
°F
  
Drying Time
hr
  
Rear Temperature
°F
  
Front Temperature
°F
  
Nozzle Temperature
°F
  
Mold Temperature
°F
  
Injection Notes
Temperatures are shown for PC/ABS adhesion. For better adhesion results please increase temperatures in the first 3 zones up to 15°C per zone.
Material is not hygroscopic and drying is only necessary if material was stored under moisture, however pre -drying can be useful to achieve a better adhesion result to the Nylon substrate.
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.