IDES Prospector Already have an account? Login Here

IDES

UNISOFT TPE™ ST-43A-CL-1-01

Styrene Ethylene Butylene Styrene Block Copolymer

Supplied by UNITED SOFT PLASTICS, Inc.

The technical datasheet with complete property values for UNISOFT TPE™ ST-43A-CL-1-01 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
TPE Compound based on Styrene-Ethylene/Butylene-Styrene Block Copolymer
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Features 
  • Bondability
  • Good Adhesion
  • Good Processability
  • High Clarity
  • High Elasticity
  • Low Density
  • Low Viscosity
Uses 
  • Adhesives
  • Bonding
  
Agency Ratings 
Appearance 
  • Translucent
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Molding Shrinkage - Flow
in/in
 ASTM D955
Elastomers
Nominal Value
Unit
Test Method
Tensile Strength (Yield)
psi
 ASTM D412
Tensile Elongation (Break)
%
 ASTM D412
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore A)
 
 ASTM D2240
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: UNISOFT TPE™ ST-43A-CL-1-01, UNISOFT TPE ST43ACL101, UNISOFT TPE™ , UNISOFT TPE, UNISOFTTPEST43ACL101, UNISOFTTPE, ST, ST 43 A CL 1 01, ST-43A-CL-1-01, ST43ACL101, ST:43A:CL:1:01, ST/43A/CL/1/01, ST+43A+CL+1+01, ST_43A_CL_1_01, ST 43A CL 1 01, ST43, 43A, ACL, CL1, 101, Styrene Ethylene Butylene Styrene Block Copolymer, SEBS, Thermoplastic Elastomer, TPE, United Soft Plastics, StyreneEthyleneButyleneStyreneBlockCopolymer, ThermoplasticElastomer, 43ST
Features
Features may also be described by the following terms: Good Adhesion, Bondability, Bondable, High Elasticity, Highly Elastic, High Clarity, Low Viscosity, Good Processability, Easy Processing, Low Density, Low Specific Gravity.
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1).
Injection
Nominal Value
Unit
 
Rear Temperature
°F
  
Front Temperature
°F
  
Nozzle Temperature
°F
  
Mold Temperature
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.