IDES Prospector Already have an account? Login Here

IDES

Unilex™ UP 8020NS

Polypropylene Homopolymer

Supplied by United Polychem

The technical datasheet with complete property values for Unilex™ UP 8020NS is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Additive 
  • Antistatic
  • Nucleating Agent
  
Features 
  • Antistatic
  • Food Contact Acceptable
  • Nucleated
Agency Ratings 
Forms 
  • Pellets
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Melt Mass-Flow Rate (MFR) (230°C/2.16 kg)
g/10 min
 ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength 2 (Yield)
psi
 ASTM D638
Tensile Elongation 2 (Yield)
%
 ASTM D638
Flexural Modulus - 1% Secant 3
psi
 ASTM D790A
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (73°F)
ft·lb/in
 ASTM D256A
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load (66 psi, Unannealed)
°F
 ASTM D648
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Unilex™ UP 8020NS, Unilex UP 8020NS, Unilex™ , Unilex, UnilexUP8020NS, UP 8020 NS, UP 8020NS, UP8020, 8020NS, UP8020NS, Polypropylene Homopolymer, PP Homopolymer, Polypropylene, PP, United Polychem, PolypropyleneHomopolymer, PPHomopolymer, 8020UP
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1).
Notes
1Typical properties: these are not to be construed as specifications.
22.0 in/min
30.050 in/min
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.