IDES Prospector Already have an account? Login Here

IDES

Daelim Po1y® LH-144

High Density Polyethylene

Supplied by DAELIM INDUSTRIAL CO., LTD.

The technical datasheet with complete property values for Daelim Po1y® LH-144 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
Features 
  • Durable
  • Good Processability
  • Hexene Comonomer
  • High ESCR (Stress Crack Resist.)
  • Ultra High Impact Resistance
Uses 
  • Piping
Agency Ratings 
Forms 
  • Pellets
Processing Method 
  • Profile Extrusion
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ASTM D1505
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ASTM D1238
Environmental Stress-Cracking Resistance (F50)
hr
 ASTM D1693B
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength 2 (Yield)
psi
 ASTM D638
Tensile Elongation 2 (Break)
%
 ASTM D638
Flexural Modulus
psi
 ASTM D790
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact
ft·lb/in
 ASTM D256
Thermal
Nominal Value
Unit
Test Method
Vicat Softening Temperature
°F
 ASTM D1525
Additional Information
Tensile Elongation @ Brk, ASTM D638: >600%
Notched Izod Impact, ASTM D256: >30 kg.cm/cm
OIT, ASTM D2951, 200°C, Aluminum Pan: >40 min
Related Terminology
This supplier and product may also be known by these terms: Daelim Poly, Daelim Po1y

Product names can be difficult to match. You may have searched any one of these terms to find this product: Daelim Po1y® LH-144, Daelim Po1y LH144, Daelim Po1y® , Daelim Po1y, DaelimPo1yLH144, DaelimPo1y, LH, LH-144, LH144, LH:144, LH/144, LH+144, LH_144, LH 144, Polyethylene, High Density, Polyethylene High Density, HDPE, Polyethylene, PE, Daelim, PolyethyleneHighDensity, 144LH
Features
Features may also be described by the following terms: Hexene Comonomer, Good Processability, Easy Processing, High Environmental Stress Cracking Resistance, High ESCR, Stress Cracking Resistant, Ultra High Impact Resistance.
Uses
Uses may also be described by the following terms: Piping, Pipe.
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): ASTM (1).
Extrusion
Nominal Value
Unit
 
Melt Temperature
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
22.0 in/min
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.