IDES Prospector Already have an account? Login Here

IDES

Daelim Po1y® LH-418

High Density Polyethylene

Supplied by DAELIM INDUSTRIAL CO., LTD.

The technical datasheet with complete property values for Daelim Po1y® LH-418 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
Features 
  • Durable
  • Good Processability
  • Hexene Comonomer
  • High ESCR (Stress Crack Resist.)
  • Ultra High Impact Resistance
Uses 
  • Geo Membranes
  • Sheet
  
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ASTM D1505
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ASTM D1238
Environmental Stress-Cracking Resistance (F0)
hr
 ASTM D1693B
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength 2 (Yield)
psi
 ASTM D638
Tensile Elongation 2 (Break)
%
 ASTM D638
Flexural Modulus
psi
 ASTM D790
Thermal
Nominal Value
Unit
Test Method
Vicat Softening Temperature
°F
 ASTM D1525
Additional Information
Tensile Elongation @ Brk, ASTM D638, 50 mm/min: >600%
OIT, ASTM D3895, 200°C, Aluminum Pan: >40 min
PENT, ASTM F1473, 80°C, 4.8 Mpa: >5000 hr
Related Terminology
This supplier and product may also be known by these terms: Daelim Poly, Daelim Po1y

Product names can be difficult to match. You may have searched any one of these terms to find this product: Daelim Po1y® LH-418, Daelim Po1y LH418, Daelim Po1y® , Daelim Po1y, DaelimPo1yLH418, DaelimPo1y, LH, LH-418, LH418, LH:418, LH/418, LH+418, LH_418, LH 418, Polyethylene, High Density, Polyethylene High Density, HDPE, Polyethylene, PE, Daelim, PolyethyleneHighDensity, 418LH
Features
Features may also be described by the following terms: Hexene Comonomer, High Environmental Stress Cracking Resistance, High ESCR, Stress Cracking Resistant, Ultra High Impact Resistance, Good Processability, Easy Processing.
Uses
Uses may also be described by the following terms: Geomembranes, Geo Membranes.
Injection
Nominal Value
Unit
 
Processing (Melt) Temp
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
22.0 in/min
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.