IDES Prospector Already have an account? Login Here

IDES

Daelim Po1y® LH-3750

High Density Polyethylene

Supplied by DAELIM INDUSTRIAL CO., LTD.

The technical datasheet with complete property values for Daelim Po1y® LH-3750 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
Features 
  • Food Contact Acceptable
  • Good UV Resistance
  • High Stiffness
Uses 
  • Industrial Containers
  • Tanks
  
Agency Ratings 
 
Forms 
  • Pellets
Processing Method 
  • Rotational Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ASTM D1505
Melt Mass-Flow Rate (MFR)
g/10 min
 ASTM D1238
Environmental Stress-Cracking Resistance (F50)
hr
 ASTM D1693A
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength (Break)
psi
 ASTM D638
Flexural Modulus
psi
 ASTM D790
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (-4°F)
ft·lb/in
 ASTM D256
Thermal
Nominal Value
Unit
Test Method
Brittleness Temperature
°F
 ASTM D746
Oxidation Induction Time 2 (392°F)
hr
 ASTM D2951
Related Terminology
This supplier and product may also be known by these terms: Daelim Poly, Daelim Po1y

Product names can be difficult to match. You may have searched any one of these terms to find this product: Daelim Po1y® LH-3750, Daelim Po1y LH3750, Daelim Po1y® , Daelim Po1y, DaelimPo1yLH3750, DaelimPo1y, LH, LH-3750, LH3750, LH:3750, LH/3750, LH+3750, LH_3750, LH 3750, Polyethylene, High Density, Polyethylene High Density, HDPE, Polyethylene, PE, Daelim, PolyethyleneHighDensity, 3750LH
Features
Features may also be described by the following terms: Good UV Resistance, UV Resistant, Ultraviolet Resistant, Ultraviolet Light Resistant, High Stiffness.
Uses
Uses may also be described by the following terms: Industrial Containers, Industrial Containers.
Agency Ratings
This plastic material has 2 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1), ASTM (1).
Injection
Nominal Value
Unit
 
Processing (Melt) Temp
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
2Al Pan
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.