IDES Prospector Already have an account? Login Here

IDES

UBE Polyethylene J3519

Polyethylene

Supplied by UBE America, Inc.

The technical datasheet with complete property values for UBE Polyethylene J3519 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Features 
  • Good Flow
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ASTM D1505
Melt Mass-Flow Rate (MFR)
g/10 min
 ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength (Break)
psi
 ASTM D638
Tensile Elongation (Break)
%
 ASTM D638
Apparent Bending Modulus
psi
 ASTM D747
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore D)
 
 ASTM D2240
Thermal
Nominal Value
Unit
Test Method
Brittleness Temperature
°F
 ASTM D746
Vicat Softening Temperature
°F
 ASTM D1525
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: UBE Polyethylene J3519, UBE Polyethylene , UBEPolyethyleneJ3519, UBEPolyethylene, PolyethyleneJ 3519, PolyethyleneJ3519, Polyethylene, J 3519, J3519, Polyethylene, Unspecified, Polyethylene Unspecified, PE, Unspecified, PE Unspecified, PE, UBE America, PolyethyleneUnspecified, PEUnspecified, 3519J, 3519PolyethyleneJ
Features
Features may also be described by the following terms: Good Flow.
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.