KERNEL KF380 Japan Polychem Plastomer, Ethylene-based

General

Material Status

Availability

Uses

Forms

Processing Method

Physical	Nominal Value	Unit	Test Method
Density		g/cm³	ISO 1183
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)		g/10 min	ISO 1133
Environmental Stress-Cracking Resistance (Compression Molded)		hr	ASTM D1693
Mechanical	Nominal Value	Unit	Test Method
Tensile Strain (Break, Compression Molded)		%	ISO 527-2
Flexural Modulus (Compression Molded)		psi	ISO 178
Impact	Nominal Value	Unit	Test Method
Charpy Unnotched Impact Strength			ISO 179
Hardness	Nominal Value	Unit	Test Method
Shore Hardness (Shore D)			ISO 868
Thermal	Nominal Value	Unit	Test Method
Brittleness Temperature		°F	ISO 974
Vicat Softening Temperature		°F	ISO 306
Melting Temperature (DSC)		°F	ISO 3146
Additional Information
Most properties were tested according to JIS standards. Tensile Elongation at Break, JIS K6922-2: >500%
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: KERNEL® KF380, KERNEL KF380, KERNEL® , KERNEL, KERNELKF380, KF 380, KF380, Plastomer, Ethylene-based, Plastomer Ethylenebased, Plastomer, Ethylene:based, Plastomer, Ethylene/based, Plastomer, Ethylene+based, Plastomer, Ethylene_based, Plastomer, Ethylene based, Plastomer, Thermoplastic Elastomer, TPE, Japan Polychem, PlastomerEthylenebased, Plastomer Ethylene_based, Plastomer Ethylene based, ThermoplasticElastomer, PlastomerEthylene_based, 380KF
Uses
Uses may also be described by the following terms: Stretch Wrap.

Notes

¹Typical properties: these are not to be construed as specifications.

KERNEL® KF380