IDES Prospector Already have an account? Login Here

IDES

WINTEC® WFX6

Polypropylene Random Copolymer

Supplied by Japan Polychem Corporation

The technical datasheet with complete property values for WINTEC® WFX6 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
Features 
  • Low Temperature Heat Sealability
  • Random Copolymer
 
Uses 
  • Film
  • Seats
 
Forms 
  • Pellets
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
ISO 1183
Melt Mass-Flow Rate (MFR)
g/10 min
ISO 1133
Mechanical
Nominal Value
Unit
Test Method
Tensile Stress (Yield)
psi
ISO 527-2
Tensile Strain (Break)
%
ISO 527-2
Flexural Modulus
psi
ISO 178
Flexural Strength
psi
ISO 178
Impact
Nominal Value
Unit
Test Method
Charpy Unnotched Impact Strength (73°F)
 
ISO 179
Hardness
Nominal Value
Unit
Test Method
Rockwell Hardness (R-Scale)
 
ISO 2039-2
Thermal
Nominal Value
Unit
Test Method
Melting Temperature (DSC)
°F
ISO 3146
Additional Information
All properties were tested according to JIS standards.
Tensile Elongation at Break, JIS K7162: >400%
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: WINTEC® WFX6, WINTEC WFX6, WINTEC® , WINTEC, WINTECWFX6, WFX 6, WFX6, Polypropylene Random Copolymer, PP Random Copolymer, Polypropylene, PP, Japan Polychem, PolypropyleneRandomCopolymer, PPRandomCopolymer, 6WFX
Features
Features may also be described by the following terms: Random Copolymer, Low Temperature Heat Sealability, Low Temperature Heat Seal.
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.