IDES Prospector Already have an account? Login Here

IDES

Borealis PE CG9620

High Density Polyethylene

Supplied by Borealis AG

The technical datasheet with complete property values for Borealis PE CG9620 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
CG9620 is a HDPE extrusion coating grade. It is suitable for wide a wide range of applications where either property enhancements or material down gauging is a target. Compared with standard LDPE the use of CG9620 enables improved water vapor barrier and higher temperature and grease resistance. Applying HDPE in extrusion coating is beneficial in cases where low surface friction (C.O.F.) or improved mechanical properties, like stiffness, are needed.
Due to the HDPE specific linear molecular structure it is recommended to use CG9620 in co-extrusion with autoclave coating LDPE (like CA8200). Processing of CG9620 does not require any extruder modifications.
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
  • North America
  • South America
Features 
  • Autoclavable
  • Food Contact Acceptable
  • Good Stiffness
  • Grease Resistant
  • High Density
  • Low Friction
  • Moisture Barrier
  • Recyclable Material
Uses 
  • Coating Applications
Forms 
  • Pellets
Processing Method 
  • Coextrusion
  • Extrusion
  • Extrusion Coating
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ISO 1183
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ISO 1133
Thermal
Nominal Value
Unit
Test Method
Melting Temperature (DSC)
°F
 ISO 3146
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Borealis PE CG9620, Borealis PE , BorealisPECG9620, BorealisPE, PECG 9620, PECG9620, PE, CG 9620, CG9620, Polyethylene, High Density, Polyethylene High Density, HDPE, Polyethylene, Borealis, PolyethyleneHighDensity, 9620CG, 9620PECG
Features
Features may also be described by the following terms: High Density, High Specific Gravity, Moisture Barrier, Low Friction, Good Stiffness, Autoclavable, Autoclave.
Extrusion
Nominal Value
Unit
Test Method
Cylinder Zone 1 Temp.
°F
  
Cylinder Zone 2 Temp.
°F
  
Cylinder Zone 3 Temp.
°F
  
Cylinder Zone 4 Temp.
°F
  
Cylinder Zone 5 Temp.
°F
  
Melt Temperature
°F
  
Die Temperature
°F
  
Maximum Coating Speed
ft/sec
 Internal Method
Minimum Coating Weight
lb/ream
 Internal Method
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.