IDES Prospector Already have an account? Login Here

IDES

Zhongfa PA66 ST-12

Polyamide 66

Supplied by Yuyao Zhongfa Engineering Plastics Co. Ltd.

The technical datasheet with complete property values for Zhongfa PA66 ST-12 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Discontinued
Availability 
  • Asia Pacific
Features 
  • High Impact Resistance
  • Low Temperature Impact Resistance
  
Uses 
  • Appliances
  • Automotive Applications
  • Electrical/Electronic Applications
  • Furniture
  • Sporting Goods
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Melt Mass-Flow Rate (MFR)
g/10 min
 ASTM D1238
Molding Shrinkage - Flow
in/in
 ASTM D955
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength
psi
 ASTM D638
Tensile Elongation (Break)
%
 ASTM D638
Flexural Modulus
psi
 ASTM D790
Flexural Strength
psi
 ASTM D790
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load (264 psi, Unannealed)
°F
 ASTM D648
Electrical
Nominal Value
Unit
Test Method
Volume Resistivity
ohm·cm
 ASTM D257
Additional Information
Notched Izod Impact, ASTM D256: 19 kJ/m²
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Zhongfa PA66 ST-12, Zhongfa PA66 ST12, Zhongfa PA66 , ZhongfaPA66ST12, ZhongfaPA66, PA 66 ST 12, PA 66 ST, ST, PA66ST-12, PA66ST12, PA66ST:12, PA66ST/12, PA66ST+12, PA66ST_12, PA66ST 12, PA66, 66ST, PA66ST, ST-12, ST12, ST:12, ST/12, ST+12, ST_12, ST 12, Polyamide 66, Nylon 66, Polyamide, Nylon, Polyamide66, Nylon66, 12ST, 66PA
Generic Name
Generic Name may also be described by the following terms: PA66.
Features
Features may also be described by the following terms: Low Temperatuer Impact Resistance, Low Temp Impact Resistance, High Impact Resistance.
Uses
Uses may also be described by the following terms: Automotive Applications, Automotive Sector, Electrical Applications, Electronic Applications, Electrical/Electronic Applications, Electrical Sector.
Injection
Nominal Value
Unit
 
Drying Temperature
°F
  
Drying Time
hr
  
Processing (Melt) Temp
°F
  
Mold Temperature
°F
  
Injection Pressure
psi
  
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.