IDES Prospector Already have an account? Login Here

IDES

Halene H HD T6

High Density Polyethylene

Supplied by Haldia Petrochemicals Ltd.

The technical datasheet with complete property values for Halene H HD T6 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
HD T6 is a general-purpose extrusion & lamination film HDPE produced by the Mitsui CX Technology.

HD T6 can be used for Lamination films, Woven sacks and Tarpaulin.

This grade is characterized by good processability and mechanical strength.
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
Features 
  • Good Processability
  • Good Strength
  
Uses 
  • General Purpose
  • Laminates
  
Forms 
  • Pellets
Processing Method 
  • Extrusion
Physical
Nominal Value
Unit
Test Method
Density 2
g/cm³
 ASTM D1505
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength 3
     ASTM D638
Yield, Compression Molded
psi
  
Break, Compression Molded
psi
  
Tensile Elongation 3 (Break, Compression Molded)
%
 ASTM D638
Flexural Modulus
psi
 ASTM D790
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (73°F)
ft·lb/in
 ASTM D256
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore D)
 
 ASTM D2240
Thermal
Nominal Value
Unit
Test Method
Melting Temperature
°F
 ASTM D3418
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Halene H HD T6, Halene H , HaleneHHDT6, HaleneH, HHD T 6, HHD T6, HHDT, HD T 6, HHDT6, HD T6, HDT, T6, HDT6, Polyethylene, High Density, Polyethylene High Density, HDPE, Polyethylene, PE, Haldia Petrochem, PolyethyleneHighDensity, THD, THHD
Features
Features may also be described by the following terms: Good Processability, Easy Processing, Good Strength.
Extrusion
Nominal Value
Unit
 
Cylinder Zone 1 Temp.
°F
  
Cylinder Zone 2 Temp.
°F
  
Cylinder Zone 3 Temp.
°F
  
Cylinder Zone 4 Temp.
°F
  
Cylinder Zone 5 Temp.
°F
  
Die Temperature
°F
  
Extrusion Notes
Quench Temperature: 25°C
Notes
1Typical properties: these are not to be construed as specifications.
223°C
3Type IV
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.