|
Density
|
|
g/cm³
|
ASTM D1505 |
|
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
|
|
g/10 min
|
ASTM D1238 |
|
Film Thickness - Tested
|
|
mil
|
|
|
Secant Modulus
|
|
|
ASTM D882 |
|
1% Secant, MD: 1.0 mil, Cast Film
|
|
psi
|
|
|
1% Secant, TD: 1.0 mil, Cast Film
|
|
psi
|
|
|
Tensile Strength
|
|
|
ASTM D882 |
|
MD: Yield, 1.0 mil, Cast Film
|
|
psi
|
|
|
TD: Yield, 1.0 mil, Cast Film
|
|
psi
|
|
|
MD: Break, 1.0 mil, Cast Film
|
|
psi
|
|
|
TD: Break, 1.0 mil, Cast Film
|
|
psi
|
|
|
Tensile Elongation
|
|
|
ASTM D882 |
|
MD: Break, 1.0 mil, Cast Film
|
|
%
|
|
|
TD: Break, 1.0 mil, Cast Film
|
|
%
|
|
|
Dart Drop Impact 2 (1.0 mil, Cast Film)
|
|
g
|
ASTM D1709 |
|
Elmendorf Tear Strength
|
|
|
ASTM D1922 |
|
MD: 1.0 mil, Cast Film
|
|
g
|
|
|
TD: 1.0 mil, Cast Film
|
|
g
|
|
|
Haze (1.00 mil, Cast Film)
|
|
%
|
ASTM D1003 |
|
Typical film property as measured on a 1.0 mil cast film sample fabricated on a 3.5" extruder at 525°F, 70°F chill roll temperature, and 13 lbs/hr/in rate.
|
|
Product names can be difficult to match. You may have searched any one of these terms to find this product: Westlake LLDPE LF 1050, Westlake LLDPE , WestlakeLLDPELF1050, WestlakeLLDPE, LLDPELF 1050, LLDPE, LLDPELF1050, LF 1050, LF1050, Polyethylene, Linear Low Density, Polyethylene Linear Low Density, Polyethylene, PE, Westlake Chem, PolyethyleneLinearLowDensity, 1050LF, 1050LLDPELF
|
|
Features may also be described by the following terms: High Stiffness, Butene Comonomer.
|
|
Uses may also be described by the following terms: Cast Film.
|
|
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1).
|