|
Density
|
|
g/cm³
|
ASTM D1505 |
|
Melt Mass-Flow Rate (MFR)
|
|
g/10 min
|
ASTM D1238 |
|
Film Thickness - Tested
|
|
mil
|
|
|
Secant Modulus
|
|
|
ASTM D882 |
|
1% Secant, MD: 2.5 mil, Blown Film
|
|
psi
|
|
|
1% Secant, TD: 2.5 mil, Blown Film
|
|
psi
|
|
|
Tensile Strength
|
|
|
ASTM D882 |
|
MD: Yield, 2.5 mil, Blown Film
|
|
psi
|
|
|
TD: Yield, 2.5 mil, Blown Film
|
|
psi
|
|
|
MD: Break, 2.5 mil, Blown Film
|
|
psi
|
|
|
TD: Break, 2.5 mil, Blown Film
|
|
psi
|
|
|
Tensile Elongation
|
|
|
ASTM D882 |
|
MD: Break, 2.5 mil, Blown Film
|
|
%
|
|
|
TD: Break, 2.5 mil, Blown Film
|
|
%
|
|
|
Dart Drop Impact 2 (2.5 mil, Blown Film)
|
|
g
|
ASTM D1709A |
|
Elmendorf Tear Strength
|
|
|
ASTM D1922 |
|
MD: 2.5 mil, Blown Film
|
|
g
|
|
|
TD: 2.5 mil, Blown Film
|
|
g
|
|
|
Typical film property as measured on a 2.5 mil blown film sample fabricated at a 2.5:1 B.U.R.
|
|
Product names can be difficult to match. You may have searched any one of these terms to find this product: Westlake LLDPE LF 2018, Westlake LLDPE , WestlakeLLDPELF2018, WestlakeLLDPE, LLDPELF 2018, LLDPE, LLDPELF2018, LF 2018, LF2018, Polyethylene, Linear Low Density, Polyethylene Linear Low Density, Polyethylene, PE, Westlake Chem, PolyethyleneLinearLowDensity, 2018LF, 2018LLDPELF
|
|
Features may also be described by the following terms: High Stiffness, Good Dimensional Stability, Dimensionally Stable, Good Tear Strength, High Tensile Strength, Hexene Comonomer.
|
|
Uses may also be described by the following terms: Heavy-duty Bags, Heavy Duty Bags.
|
|
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1).
|