IDES Prospector Already have an account? Login Here

IDES

HI-ZEX™ 550P

High Density Polyethylene

Supplied by Prime Polymer Co., Ltd.

The technical datasheet with complete property values for HI-ZEX™ 550P is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
  • Europe
  • North America
Features 
  • High ESCR (Stress Crack Resist.)
Uses 
  • Piping
Forms 
  • Pellets
Processing Method 
  • Extrusion
  • Pipe Extrusion
  
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ISO 1183
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ISO 1133
Environmental Stress-Cracking Resistance (Compression Molded)
hr
 ASTM D1693
Mechanical
Nominal Value
Unit
Test Method
Tensile Modulus (Rotational Molded)
psi
 ISO 527-2
Tensile Stress (Yield, Compression Molded)
psi
 ISO 527-2
Tensile Strain (Break, Compression Molded)
%
 ISO 527-2
Flexural Modulus (Compression Molded)
psi
 ISO 178
Impact
Nominal Value
Unit
Test Method
Charpy Unnotched Impact Strength (Compression Molded)
ft·lb/in²
 ISO 179
Hardness
Nominal Value
Unit
Test Method
Shore Hardness (Shore D, Compression Molded)
 
 ISO 868
Thermal
Nominal Value
Unit
Test Method
Vicat Softening Temperature
°F
 ISO 306
Melting Temperature (DSC)
°F
 ISO 3146
Additional Information
The value listed as Melting Temperature, ISO 3146, was tested in accordance with ISO 11357-3
Tensile Strain at Break, ISO 527: >300%
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: HI-ZEX™ 550P, HIZEX 550P, HI-ZEX™ , HIZEX, HI:ZEX™, HI/ZEX™, HI+ZEX™, HI_ZEX™, HI ZEX™, HIZEX550P, HI_ZEX, HI ZEX, 550 P, 550P, Polyethylene, High Density, Polyethylene High Density, HDPE, Polyethylene, PE, PolyethyleneHighDensity, P550
Features
Features may also be described by the following terms: High Environmental Stress Cracking Resistance, High ESCR, Stress Cracking Resistant.
Uses
Uses may also be described by the following terms: Piping, Pipe.
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.