IDES Prospector Already have an account? Login Here

IDES

ULTZEX™ 3520L

Linear Low Density Polyethylene

Supplied by Prime Polymer Co., Ltd.

The technical datasheet with complete property values for ULTZEX™ 3520L is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
  • Europe
  • North America
Features 
  • Good Heat Seal
  • Good Stiffness
  • High Heat Resistance
Uses 
  • Film
  • Laminates
  
Processing Method 
  • Film Extrusion
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ISO 1183
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ISO 1133
Environmental Stress-Cracking Resistance
hr
 ASTM D1693
Mechanical
Nominal Value
Unit
Test Method
Tensile Stress
     ISO 527-2
Yield, Injection Molded
psi
  
Break, Injection Molded
psi
  
Tensile Strain (Break, Injection Molded)
%
 ISO 527-2
Flexural Modulus (Injection Molded)
psi
 ISO 178
Impact
Nominal Value
Unit
Test Method
Charpy Unnotched Impact Strength
 
 ISO 179
Hardness
Nominal Value
Unit
Test Method
Shore Hardness (Shore D, Injection Molded)
 
 ISO 868
Thermal
Nominal Value
Unit
Test Method
Vicat Softening Temperature
°F
 ISO 306
Melting Temperature
°F
 ISO 11357-3
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: ULTZEX™ 3520L, ULTZEX 3520L, ULTZEX™ , ULTZEX, ULTZEX3520L, 3520 L, 3520L, Polyethylene, Linear Low Density, Polyethylene Linear Low Density, LLDPE, Polyethylene, PE, PolyethyleneLinearLowDensity, L3520
Features
Features may also be described by the following terms: High Heat Resistance, Good Stiffness, Good Heat Seal.
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.