IDES Prospector Already have an account? Login Here

IDES

Ateva® 1807A

Ethylene Vinyl Acetate Copolymer

Supplied by Celanese EVA Performance Polymers

The technical datasheet with complete property values for Ateva® 1807A is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
This resin is well suited for film extrusion and coextrusion with other polymers where superior strength and good heat seal characteristics are required.
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Additive 
  • Antioxidant
Features 
  • Antioxidant
  • Good Heat Seal
  • High Strength
Agency Ratings 
Forms 
  • Pellets
Processing Method 
  • Coextrusion
  • Film Extrusion
  
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ASTM D1505
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ASTM D1238
Vinyl Acetate Content
wt%
  
Films
Nominal Value
Unit
Test Method
Tensile Strength 2
     ASTM D882A
MD: Yield, 5.1 mil
psi
  
TD: Yield, 5.1 mil
psi
  
MD: Break, 5.1 mil
psi
  
TD: Break, 5.1 mil
psi
  
Tensile Elongation 2
     ASTM D882A
MD: Break, 5.1 mil
%
  
TD: Break, 5.1 mil
%
  
Dart Drop Impact 3 (0.98 mil)
g
 ASTM D1709
Thermal
Nominal Value
Unit
Test Method
Vicat Softening Temperature
°F
 ASTM D1525
Melting Temperature
°F
 DSC
Optical
Nominal Value
Unit
Test Method
Gloss (45°, 5.12 mil)
 
 ASTM D2457
Haze (5.12 mil)
%
 ASTM D1003
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Ateva® 1807A, Ateva 1807A, Ateva® , Ateva, Ateva1807A, 1807 A, 1807A, Ethylene Vinyl Acetate Copolymer, EVA, Polyethylene, PE, Celanese EVA, EthyleneVinylAcetateCopolymer, A1807
Features
Features may also be described by the following terms: High Strength, Good Heat Seal.
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1).
Extrusion
Nominal Value
Unit
 
Melt Temperature
°F
  
Extrusion Notes
Recommendations: 130µm film produced on a 24:1 L/D, 40mm extruder with a 100mm die and a 2.5:1 blow up ratio.
Notes
1Typical properties: these are not to be construed as specifications.
220 in/min
3F50
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.