| Maleic Anhydride Grafted Polymer (MAH-g)
Processing Information |
|
|
English
|
| Specific Gravity | 0.875 to 0.962 | | Mold Shrinkage, Flow (in/in) | -- | | Melt Mass Flow Rate (g/10 min) | 1.0 to 12 | | Drying Temperature (°F) | -- | | Drying Time (hr) | -- | | Suggested Max Moisture (%) | -- | | Suggested Max Regrind (%) | -- | | Injection Pressure (psi) | -- | | Rear Temperature (°F) | -- | | Middle Temperature (°F) | -- | | Front Temperature (°F) | -- | | Nozzle Temperature (°F) | -- | | Processing (Melt) Temp (°F) | -- | | Mold Temperature (°F) | -- |
SI
|
| Specific Gravity (g/cm³) | 0.873 to 0.960 | | Mold Shrinkage, Flow (cm/cm) | -- | | Melt Mass Flow Rate (g/10 min) | 1.0 to 12 | | Drying Temperature (°C) | -- | | Drying Time (hr) | -- | | Suggested Max Moisture (%) | -- | | Suggested Max Regrind (%) | -- | | Injection Pressure (MPa) | -- | | Rear Temperature (°C) | -- | | Middle Temperature (°C) | -- | | Front Temperature (°C) | -- | | Nozzle Temperature (°C) | -- | | Processing (Melt) Temp (°C) | -- | | Mold Temperature (°C) | -- |
|
|